Mass moment of inertia via setpoint connection
- Menu: 4.4.6-1.2-1
- Index: 8506.2
Description
Specifies whether the mass moment of inertia and a torque precontrol value for changing the mass moment of inertia are specified to the inverter via the motor angle. This allows for faster balancing.
This setting can be used if the track is subject to a position-dependent load torque (e.g. toggle mechanism) but the controller still has to be set stiffly.
The following settings are possible:
Setting | Meaning |
|---|---|
0 (no) | The mass moment of inertia, which has been taken into operation in the active drive train, is adopted. Torque precontrol is not active. |
1 (yes) | The values from the parameters Mass moment of inertia and Torque precontrol (Parametergruppe Setpoints > Setpoint value connection) are adopted. |
DefaultSetting
0 (no)
