Digital learning opportunities for MOVITRAC®

Close table
MOVITRAC® B frequency inverters Description
In this E-learning course, you will get to know MOVITRAC® B and its key features. You will also gain insight into the MOVITRAC® B’s areas of application and product family.

Learning goals:

  • Being able to identify MOVITRAC® B.
  • Getting to know the key features of MOVITRAC® B.
  • Being able to categorize MOVITRAC® B in the product family.
  • Getting to know the areas of application of MOVITRAC® B.

Available in the following languages:
DE | EN

Duration:
15 minutes

Type of knowledge:
Product knowledge
We have stored a table for you here.

MOVITRAC® B - Startup

Close table
SEW image Description:
In this learning unit, you will learn how to put the MOVITRAC® B into operation. For this purpose, you will receive the corresponding information on startup requirements and, in a tutorial, will then be guided through the subsequent steps one step at a time. You will familiarize yourself with manual mode to test whether the startup was successful.

Learning goals:

  • Being able to make preparatory settings.
  • Being able to establish communication between the PC and product.
  • Being able to configure parameters for startup.
  • Being able to perform a test run in manual mode.

Available in the following languages:
DE | EN

Duration:
15 minutes

Type of knowledge:
Hands-on-tutorial
We have stored a table for you here.

MOVITRAC® B - Device replacement

Close table
SEW image Description:
Description
In this e-learning you will learn how to replace a MOVITRAC® B inverter with and without data backup.


Learning goals:

  • Learn to replace a MOVITRAC® B inverter
  • Learn to perform a data backup


Available in the following languages:
DE | EN

Duration:
30 minutes

Type of knowledge:
Product knowledge
We have stored a table for you here.

Engineering-Software MOVITOOLS®

MOVITOOLS® MotionStudio – Diagnostics and controller optimization with Scope

Close table
SEW image Description:
In this learning unit, you will learn how to set up the MOVITOOLS® MotionStudio 'Scope' tool and perform a recording with controller optimization and fault diagnostics. For this purpose, you will be guided step by step through the operation of the Scope tool in three tutorials.

Learning goals:

  • To be familiar with the basic operation of the Scope tool
  • To be able to set up, operate and perform a Scope measurement
  • To be able to perform controller optimization and fault diagnostics with Scope



Available in the following languages:
DE | EN

Duration:
60 minutes

Type of knowledge:
Product knowledge
We have stored a table for you here.

Never miss new online learning content ever again

Keep up to speed and never miss new E-learning courses from SEW-EURODRIVE ever again. Register for information about new or updated E-learning courses. Please fill in the following form.

Feedback
SEW image

Your opinion is important to us!

We want to continually expand our digital learning opportunities for you. Please provide us with your feedback. What do you like? What do you miss? We look forward to receiving your feedback

Support
SEW image

FAQ

If you have any questions about the learning units, our FAQ page may be able to help. Should you have any other questions not covered there or want to share comments, please feel free to get in touch