Digital learning offer for MOVIDRIVE® B

Our current learning opportunities for the MOVIDRIVE® B frequency inverters provide the essential basic principles for your work with MOVIDRIVE® B, including how to replace a device if necessary.

MOVIDRIVE® B drive inverter

MOVIDRIVE® B - Overview

Close table
MOVIDRIVE® B Description
In this E-learning course, you will get to know the MOVIDRIVE® B. You will also gain insight into the MOVIDRIVE® B’s areas of application and product family.

Learning goals:

  • Being able to identify MOVIDRIVE® B.
  • Getting to know the key features of MOVIDRIVE® B.
  • Being able to categorize the MOVIDRIVE® B in the product portfolio.
  • Getting to know the areas of application of MOVIDRIVE® B.

Available in the following languages:
DE | EN

 Duration:
15 minutes

Type of knowledge:
Product knowledge
We have stored a table for you here.
Back to top

MOVIDRIVE® B - Startup

Close table
MOVIDRIVE® B Description:
In this learning unit, you will learn how to put the MOVIDRIVE® B into operation. For this purpose, you will receive the corresponding information on startup requirements and, in a tutorial, will then be guided through the subsequent steps one step at a time. At this point, you can decide whether you wish to perform the startup with or without an encoder. You will familiarize yourself with manual mode to test whether the startup was successful.

Learning goals:

  • Being able to make preparatory settings.
  • Being able to establish communication between the PC and product.
  • Being able to perform a factory setting.
  • Being able to configure parameters for startup.
  • Being able to perform a test run in manual mode.

Available in the following languages:
DE | EN

 Duration:
20 minutes

Type of knowledge:
Hands-on-tutorial
We have stored a table for you here.
Back to top

MOVIDRIVE® B - Device replacement

Close table
MOVIDRIVE® B Description:
In this learning unit, you will learn how to replace a MOVIDRIVE® B device both with and without backing up data.

Learning goals:

  • Being able to replace the MOVIDRIVE® B inverter.
  • Being able to back up data.

Available in the following languages:
DE | EN

 Duration:
15 minutes

Type of knowledge:
Hands-on-tutorial
We have stored a table for you here.
Back to top

Engineering-Software MOVITOOLS®

MOVITOOLS® MotionStudio – Diagnostics and controller optimization with Scope

Close table
SEW image Description:
In this learning unit, you will learn how to set up the MOVITOOLS® MotionStudio 'Scope' tool and perform a recording with controller optimization and fault diagnostics. For this purpose, you will be guided step by step through the operation of the Scope tool in three tutorials.

Learning goals:

  • To be familiar with the basic operation of the Scope tool
  • To be able to set up, operate and perform a Scope measurement
  • To be able to perform controller optimization and fault diagnostics with Scope



Available in the following languages:
DE | EN

 Duration:
60 minutes

Type of knowledge:
Product knowledge
We have stored a table for you here.
Back to top

Never miss new online learning content ever again

Keep up to speed and never miss new E-learning courses from SEW-EURODRIVE ever again. Register for information about new or updated E-learning courses. Please fill in the following form.

Feedback
SEW image

Your opinion is important to us!

We want to continually expand our digital learning opportunities for you. Please provide us with your feedback. What do you like? What do you miss? We look forward to receiving your feedback

Support
SEW image

FAQ

If you have any questions about the learning units, our FAQ page may be able to help. Should you have any other questions not covered there or want to share comments, please feel free to get in touch

Back to top